![]() ![]() To remove fresh stains wipe with a slightly damp cloth. Ingress Protection IP20, IEC Protection Class II, CE marking Also available with direct wall mounting. ![]() Please contact your local electrician.Ģ40 cm, textile cable, switch on the cable. Due to great variation in DALI systems, Secto Design does not supply DALI-dimmers. Comes with a LED bulb (Airam Pro LED, E14, 6 W, 470 lumen, 3000 K, pure white, dimmable, may vary). The use of special bulbs such as halogen, mirror or 12 V bulbs in Secto Design lamps is prohibited, due to overheating. This product is supplied with an example bulb of energy efficiency class E.Īttachable to DALI systems with a separate DALI-compatible trailing edge (phase cut off) type dimmer. Height 60 cm Depth 9–18 cm Width 13–31 cm Weight 1,1 kg Package 36 × 20 × 66 cm, 2,0 kgĮ14 base, LED max 20 W. Finishing options Shadeįorm pressed birch slats, powder coated steel back plate The wood provides a soft luminosity for atmosphere and appeal. That’s it! If you have any questions or run into any problems, feel free to reach out to our customer support team.Handmade of PEFC-certified form pressed birch in Finland by highly skilled craftsmen. Note: Canopy screws are included with the wall sconce kit. ![]() We recommend using a screwdriver for this step to avoid over-tightening the screws which could damage the canopy or strip the screw threads. Screw the canopy screws into the mounting bracket. Put up the mounting bracket and screw into the drywall anchors. Note: the wall sconce kit does not come with screws or drywall anchors. Step 3 & 4 (pictured individually). Push in each drywall anchor and gently tap into place using a hammer or the back of a screwdriver. Make sure the holes are smaller and shallower than the drywall anchor so it will have a firmer connection with the drywall. Use the mounting bracket to mock up the location of the sconce. Mark the wall through the holes in the bracket to line up where the anchor holes will go. Step 1. To begin, remove the mounting bracket from the back of the sconce by unscrewing the screws. With that in mind, follow these simple steps and your sconce will be lighting up the room in no time. Finally, we recommend using screws no longer than two inches to minimize the possibility of making contact with electrical wiring in the wall. With this method, we recommend putting screws in all six holes in the mounting brackets for optimum hold. However, if you prefer to use screws without anchors, you don’t need to pre-drill holes unless you’re screwing into wood or another non-drywall material. Additionally, this guide is for mounting the sconce using drywall anchors, but this isn’t the only method for mounting. Drywall anchors greatly increase the stability of the fixture and virtually eliminate the possibility the fixture will pull out of the wall from accidental contact or daily use. ![]() Installation instructions for our key-hole bracket mounted fixtures - namely our Donna, Simone, Eduard, Astrid, and Abrams plug-in wall sconces - can be found on the resources tab on their respective product pages. Take note that the instructions below are for removable bracket mounted fixtures. All you’ll need is a power drill, a few mounting screws and drywall anchors, and your Schoolhouse wall sconce kit. View our Art Accent Chart to find the correct placement of recessed. By design, mounting a plug-in wall sconce is within the grasp of just about anyone. Wall-mounted fixtures balance overhead light sources and add that little something. Their design can fit with modern or traditional décor, and they can be mounted almost anywhere in your home. A plug-in wall sconce is a great investment for anyone who wants to upgrade their lighting but doesn’t want to hardwire a fixture. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |